Portable Dross Boss Processing Units – City Aluminum Foundry Co.

Portable Dross Boss Processing Units

1. Customer:

City Aluminum Foundry Co.
2505 Williams Dr.
Waterford, MI 48328-1869

2. Contact:

Chuck Juliarr Vice President 248-33s-8785
Customer Report

3. Melting Practices:

We pour primarily 356, 319 and 535. Our Hunter molding line has 4 Inductotherm I 300 pound resistance fumaces.

4. Practice Comparisons:

We typically get two batches from each furnace per day. We flux inject these furnaces. With a brick drossing table, we were generating around I drum of dross. weighing around 400 pounds, per day. With the DROSS BOSSTN4, we generate one drum of dross every three days. The difference is in recovered aluminum. It seems as though we are saving 800 pounds of metal every three days. It has been possible to reduce our loss by very diligently having the furnace tenders massage the dross and get it to drain, but once you stop watching them, they slip back into their old ways because of the time it takes and we again have a lot of lost metal. We consistently get good recovery with the DROSS BOSS rM.

5. DROSS BOSSTNt Practices:

The basic treatment cycle identified above was followed with the heats processed through the DROSS BOSSIM, with the exception of a two ounce addition of exothennic flux stirred into the dross that had been transferred into the reaction vessel. The rnanual stirring operation was accomplished in less than three minutes, with the recovered metal being returned at elevated temperature to tlte holding furnace. No significant change in metal chemistry had occurred during processing.

6. Customer Savings:

Using a conservative estimate of savings, the customer projected an approximate ($139/ day)* direct savinqs in metallics, rvith an additional saving in remelt energy by recharging tlie hot material to his melter. On that basis, their return on the capital investment was achieved in approximately three months.

*2013 prices

Click here to view full version.

Leave a Reply

Your email address will not be published. Required fields are marked *